Headlight bracket schmidt delux
With tightening strap by Rixen & Kaul, tape lenght 130 mm to be mounted on handle bar or sterm with a diameter from 22 to 31, 8 mm. For LED headlight Edelux including ring terminal (for ground connection)
Push one end of the tightening strap from below through the tension plate and bend it. Place tension strap around handle bar/ stem, take it throught the other slot plate, pull slightly tight and bend it over likewise. Both ends overlap approx. 1 to 2 cm on each side - trim then if necessary.
Mount and adjust round base and bracjet with the screw - grease head and thread in advance and tighten firmly.
On carbon handle bars use a rubber pad for protection below the stainless steel band and clamp the strap not too tight.
Mognettibike ships worldwide
During confirmation of the order, you will then be able to select the most appropriate courier service for your delivery address by choosing from the main shipping services of any country with relative prices, delivery times and accessory options.
It is necessary to specify an address where there is always someone available (even at work, a neighbour etc ..), a phone number where there is always availability. In case of delivery failure the courier may contact you or leave a delivery note with instructions to follow.
All shipping services have a tracking number which is sent to the customer by email once the order has been shipped so as to keep track on the process. (do note for some services the tracking number will only be available after 24hours).